CHLORINATED RUBBER FINISH

 
A gloss finish for use with CR Thick coat where a decorative finish, or a wider colour range is required. Chlorinated Rubber Finish should be specified where protection is required against severe chemical spillage, very wet or damp conditions. It should not be used where solvent spillage occurs, or where resistance to vegetable or other oils is required. It has excellent resistant to mould growth and is suitable for the protection of cement or masonry surfaces in Laboratories, Chemical Factories, toilets, etc. It is single-pack and has no re-coat limitations. The quick drying time assists in plant maintenance work during brief shut-down periods.
 
PHYSICAL CHARACTERISTICS OF WET PAINT (TYPICAL FIGURES)
(Colour - White Other colours will dry)
Pigment composition Titanium Dioxide
Pigment % 15 ± 2
Binder type Plasticised chlorinated rubber
Binder % 30 ± 2
Thinner composition Aromatic hydrocarbons
Thinner % 54 ± 2
Volume solids % 30 ± 2
Specific gravity of paint 1.13 ± 0.02
 
PHYSICAL CHARACTERISTICS OF DRY FILM :
Drying time of Standard thickness at 30ºC 4 hour
at 20ºC 5 hour
At 7ºC 6 hour
Recoating times(minimum) By spray 8 hours, by brush 24 hours
Standard thickness required Wet paint 80-130 microns (3.2-5.2 Mils)
Dry Film 25-40 (1-1.5 Mils)
Theoretical coverage on smooth 7.55 - 12.1 m2/1 Surface 7.5-12.0 M2/litre
   
NOTE Chlorinated rubber coating have poor resistance to oil land solvents. Heat resistance is Poor. Do not apply to surfaces which exceed 65ºC. Not suitable for self weathering.
APPLICATION
Brush / Roller Ready for use
Conventional spray  
Thinner addition by volume 10-15%
Recommended Thinner Chlorinated Rubber Thinner
   
SURFACE PREPARATION Use over Chlorinated Rubber Thickcoating. The coating should be clean, dry and free from grease and chemical contaminants. The removal of contaminants must include washing with fresh water to remove soluble salts.
 
Chemical and Water Resistance Chlorinated Rubber Coating systems applied to correctly prepared surfaces will withstand immersion in sea and fresh water (not recommended for surfaces in contact with drinking water), dilute acids and alkalis, alphatic hydrocarbons , concentrated acids and alkalis. For resistance to vegetable oils, chlorinated solvents, ketones, aromatic hydrocarbons and esters, an Epoxy Finish system is preferred.
   
Heat Resistance On dry heated metal surfaces, upto 65ºC (130ºF) on immersed surfaces, upto 43ºC (110ºF)
   
PACK SIZE 20 Litres, 4 Litres