Polyamide cured solvent less Epoxy - based
clear Primer.
COMPOSITION
Polyamide cured solvent less Epoxy - based clear Primer.
RECOMMENDED USE
Recommended as a Primer for hygienic and heavy duty
flooring in sterile area and O.E. as well as tank inside coating for
concrete storage tank. This product is used as binder for tile fixing
also. This product gives the best result when used in combination
with our Bluray's HISOLS 271.
PHYSICAL CONSTANTS
Color
Clear
Finish
Glossy
Solids by
volume
98%
Theoretical
spreading rate
7.8 sq.mtr./ltr.
at recommended D.F.T. on smooth and non absorbent surface.
Flash
Point
Above 25 deg. C.
Drying Characterstics
DRY TO TOUCH
: Overnight DRY TO HANDLE : 48 hrs. FULLY CURED : 7 days
Shelf Life
6 months (of individual
component) - Stored under proper condition of temp. & pressure.
APPLICATION DETAIL
Mixing
Ratio (BY VOL.)
Base :
Hardner - 2 :1
Pot
life
1/2 -
1 hrs. at 25 deg. C.
Application
method
By Brush By trawley
By airless Spray
Thinner
Type 002 (if req.)
Type 002 (if requ.) Type 002
Recommended
dry film Thickness
25 microns
Indicated
Film Thickness
WET
: 127.5 microns DRY : 125 microns
Overcoating
interval
MIN.
: Overnight MAX. : 5 days
Compatibility
Can be top coated
with Epoxy and Polyurethane, C.R., Top coats.
SURFACE
PREPARATION
CONCRETE
: New Concrete : Ensure that the concrete is cured for minimum
of three months. The surface is to be made rough and free from
algi, bacteria and other contaminants by sand sweeping. Old
Concrete : Remove all salt deposits from the surface by water
jet washing. Light sand blast the surface to remove all loosely
bound coatings and roughening up of firmly adherning coatings
to ensure anchorage with recommended system. Ensure all dust
/ other particles are fully removed by suction on air blast
and the surface is fully cleaned and dried, apply our penetrating
primer Bluray PRIME PRIME 200 before application of this primer.
If non-critical areas where blasting is not possible, water
jet washing and hard wire brushing are minimum requisites. The
surface should be cleaned and dried before application of Bluray
PRIME 208.
FILM PROPERTY
CHEMICAL RESISTANCE
EXPOSURES -SPLASH
&SPILLAGE-FUMES
ACIDS
Good
Excellent
ALKALITES
VGood
Excellent
SOLVENTS
Excellent
Excellent
SALTS
Excellent
Excellent
WATER
Excellent
Excellent
TEMPERATURE
RESISTANCE
CONTINUOUS : 93
deg. C. INTERMITTENT : 120 deg. C.
WEATHERABILITY
Very Good with suitably top coated.
FLEXIBILITY
Excellent
ABRASION
RESISTANCE
Excellent
NOTES
1. Do not
apply when temperature falls below 10 deg. C. or rises above
50 deg. C. and when relative humidity rises above 90%. Do not
apply during rain, fog and mist.
2. Brushes and spray equipment should be cleaned with Bluray's
Thinner otherwise equipment is liable to be damaged.
3. Etch Primed steel work should not be exposed before being
overcoated with priming / or finishing coat for added protection.
