|
GENERIC TYPE : |
Two Component |
| |
| COMPOSITION : |
Aromatic Polyurethane-based clear. |
| |
| RECOMMENDED USE : |
As penetrating primer for concrete and wood
surface. |
| |
|
PHYSICAL CONSTANTS : |
|
| |
| Color |
Assorted Shades
|
| Finish |
Glossy/Semi Glossy/Matt
|
| Solids by volume |
40% +- 2% |
| Theoretical Spreading
Rate |
13.3 - 16 sq.mtr./ltr.
at recommended D.F.T. on smooth and non absorbent surface. |
| Flash Point |
Above 25 deg.
C. |
| Drying Characterstics
|
DRY TO TOUCH : 1-2 hrs.
DRY TO HANDLE : 24 hrs.
FULLY CURED : 7days |
| Shelf Life |
6 months (of individual
component) - Stored under proper condition of temp.
& pressure. |
|
|
APPLICATION DETAIL : |
|
| |
| Mixing Ratio (BY
VOL.) |
Base : Hardner-
9 : 1 |
| Pot life |
4-6 hrs. at 25
deg. C. |
| Application method |
By Brush or By
Spray |
| Thinner |
Bluray PU Thinner |
| Recommended dry
film Thickness |
25 microns |
| Indicated Film
Thickness |
WET : 62.5 - 75 microns
DRY : 25 - 30 microns |
| Overcoating interval |
MIN. : 8 hrs. MAX.
: 24 hrs. |
| Compatibility |
Can be top coated
with Epoxy, PU, C.R. top coats. |
|
| SURFACE PREPARATION : |
| |
| Concrete |
|
| New Concrete |
Ensure that the
concrete is cured for minimum three months. The surface
is to be made rough and free from bacteria and other
contaminants by sand sweeping. |
| Old Concrete |
Remove all salt
deposit from the surface by water jet washing. Light
sand blast the surface to remove all loosely bound coatings
and roughening up of firmly adherning coatings to ensure
anchorage with recommended system. Ensure all dust /
other particles are fully removed by suction on air
blast and the surface is fully cleaned and dried before
application of paints. |
|
| FILM PROPERTY CHEMICAL RESISTANCE : |
| |
| EXPOSURES-SPLASH
&SPILLAGE-FUMES |
|
ACIDS |
Fair |
Good |
|
ALKALITES |
Good |
Good |
|
SOLVENTS |
Good |
Good |
|
SALTS |
Good |
Good |
|
WATER |
Fair |
Good |
|
|
| TEMPERATURE RESISTANCE
: |
CONTINUOUS : 93 deg. C.
INTERMITTENT : 120 deg.C. |
| WEATHERABILITY
: |
Very Good. Should
be top coated for maximum durability |
| FLEXIBILITY : |
Very Good |
| ABRASION RESISTANCE
: |
Good |
|
| Notes : |
| 1 |
Do not apply when
temperature falls below 10 deg. C. or rises above 50 deg.
C. and when relative humidity rises above 90%. Do not
apply during rain, fog and mist. |
|
2 |
Brushes and spray
equipment should be cleaned with Bluray's Thinner other-wise
equipment is liable to be damaged. |
|
3 |
Etch Primed steel
work should not be exposed before being overcoated with
priming / or finishing coat for added protection. |
|
|
Pack Size : |
20 Litres, 4 Litres |
