RED OXIDE ZINC CHROMATE PRIMER

 
Established in use under variety of conditions for many years, this is an Alkyd based /Red Oxide Zinchromate with excellent corrosive properties, combined with good stability and Easy application. It is used as a anticorrosive primer over steel surfaces.
 
PHYSICAL CHARACTERISTICS OF WET PAINT (TYPICAL FIGURES)
 
Pigment composition Zinc Chrome Iron oxide and mineral extenders
Pigment % 45 ± 2
Binder type Alkyd & Phenolic Resin
Thinner composition Aliphatic hydrocarbon
 
PHYSICAL CHARACTERISTICS OF DRY FILM :
Drying time of Standard thickness 6 hours
Recoating times(minimum) Normally 6 hours, but allow longer under cold damp conditions.
Standard thickness required Dry film 20 - 25 microns
Theoretical coverage on smooth surfaces 12-14 m2/litre
   
APPLICATION
Brush / Roller Ready for use
Conventional spray Recommended
Airless spray Not recommended
Thinner Bluray Thinner-600
   
SURFACE PREPARATION Ensure surface is clean, dry and free from loose millscale, rust, grease, wax, soluble salts and other contaminants. Remove all loose or defective paint or primer. Prime immediately after preparation.
 
PACK SIZE 20 Litres, 4 Litres